Inconel group of alloys, particularly IN 625 and IN 718 are the most widely recognized
commercially available Ni-based superalloys employed for high temperature applications …

Additive manufacturing of high-entropy alloys (HEAs) might lead to defects in the as-built
condition such as porosity, residual stresses, elemental segregation, lack of fusion, and …

The microstructures of additively manufactured Inconel 718 consist of the primary phase
(dendritic) and the secondary phases (Laves and carbides). Among the secondary phases …

The corrosion behavior of Inconel 718 (IN718) superalloy fabricated using wire-arc additive
manufacturing (WAAM) and post-deposition heat treatment is investigated and compared to …

Nickel-based superalloys are widely used in aircraft engines and land-based gas turbines
due to their high yield strength and good creep resistance. Co in nickel-based superalloys …

This study aims to address the fact that after the selective laser melting (SLM) of an Inconel
718 alloy, the microstructures at each fabrication position are anisotropic due to the coupling …

The uniform refinement mechanisms and methods of deformed mixed and coarse grains
inside a solution-treatment Ni-based superalloy during two-stage annealing treatment have …

While understanding the precipitation kinetics of gamma double prime (γ ″) phase is of vital
importance in Inconel 718 superalloy, kinetics studies by Johnson–Mehl–Avrami …

The effect of initial mixed grain microstructure state of deformed Ni-based superalloy on its
refinement behavior during two-stage annealing treatment was investigated. Firstly, the …

Tension compression experiments were performed on Ni-base superalloy 718 single and
polycrystals to investigate the effects of nanoscale γ''precipitates on cyclic deformation …