Ceramics are usually composed of randomly oriented grains and intergranular phases, so
their properties are the statistical average along each direction and show isotropy …

Electrical steels can be classified into two groups: grain-oriented (GO) and non-oriented
(NGO) electrical steel. NGO electrical steels are mainly considered as core materials for …

As a most widely applied structure material, the deformed characteristics of steels primarily
presented the adiabatic shear band (ASB) formation and phase transitions, instead of its …

This paper presents a systematic study of structure and mechanical behavior of Ti/Fe
explosive-bonded interfaces. The transient fluid-like behavior at the bonding zone is …

We investigate the effect of annealing on the properties of Fe-6.9 wt% Si produced by
Selective Laser Melting (SLM), a powder-bed additive manufacturing technology. Results …

Due to the alignment of two easy< 100> axes in the sheet plane, the cube orientation
({001}< 100>) is an ideal texture for non-oriented electrical steel sheets used as core …

Abstract Increasing magnetically favorable< 100>//ND texture components is a key
challenge in the preparation of high-efficiency non-oriented electrical steels. In this study, an …

Dynamic recrystallization (DRX) is one of the more convenient and effective means of
refining grains during hot deformation, which is closely related to the precipitation behavior …

Through-process texture evolution was investigated in Fe–2.8 wt.% Si sheets cold-rolled
directly from twin-roll cast strip. A strong cube texture ({0 0 1}< 1 0 0>) is successfully …

A set of IF steel specimens, at several stages of recrystallization, were subjected to EBSD
analysis to provide data for a study of primary recrystallization. First, a criterion was defined …