In this study, equal channel angular pressing (ECAP) method is used to obtain fine grain
microstructure in Al 6061 alloy at room and elevate temperatures. The billet samples are …

Aluminium alloy is one of the earliest and most widely used superplastic materials. The
objective of this work is to review the scientific advances in superplastic Al alloys …

The ultra-fine grain structure of Al–Zn–Mg–Cu alloy was prepared by equal channel angular
pressing (ECAP) and post cold rolling (CR) combined deformation process. The effect of …

To overcome the trade-off between strength and ductility of the additively manufactured
AlSi10Mg alloy used in the automotive and aerospace industries, samples with multilevel …

Magnesium is a low-density metal which is used in extensive structural applications such as
load-bearing components in the automobile industry. To improve the strength and ductility of …

High strength and low corrosion resistance are always the contradiction in Al-Si-Cu-Mg cast
alloy due to introducing high Cu and Mg levels. In this work, the new strategy was achieved …

In this study, microstructural features direct metal laser melted (DMLM) aluminium–silicon-
magnesium (AlSi10Mg) are investigated using advanced transmission electron microscopy …

Casting experiments were carried out on Al–7Si using different additions of rare earth Ce at
a reaction temperature of 1200 K. Based on the ternary phase diagram of Al–Si–Ce, the …

In this study, the impact of four linear speeds (75, 95, 115, and 135 mm/min) during fast-
multiple rotation rolling (FMRR) on the A390 coating applied via friction surfacing (FS) on the …

In this study, the effect of severe plastic deformation on Al-Zn-Mg alloy was investigated by
ECAP method. The ECAP process parameters were determined using Taguchi experimental …